How to Swap Switches on Your Attack Shark HE Keyboard

By Attack Shark | Premium Gaming Keyboards, Mice, Headsets ... | Published: 2026-10-17

Category: How-to Guides

Learn how to safely swap magnetic switches on your Attack Shark HE keyboard. Step-by-step guide with common mistakes to avoid.

Quick Answer

To swap switches on your Attack Shark HE keyboard, power off the board, use the included switch puller to gently remove the old switch, align the new magnetic switch pins with the socket, and press firmly until it clicks. Always check that the switch is fully seated before powering back on.

What You Need Before You Start

A hot-swappable keyboard like the ATTACK SHARK X820 ULTRA or AKS068 Alice lets you change switches without soldering. For HE (Hall Effect) boards, the process is nearly identical to standard hot-swap, but you must use compatible magnetic switches. The board’s socket is designed for specific pins, so check your model’s specs before buying replacements.

You will need a switch puller (usually included with your keyboard), a keycap puller, and a clean, flat workspace. Avoid using metal tools that could scratch the PCB or bend the socket pins.

Step-by-Step Switch Swap Guide

Power Off and Disconnect: Turn off the keyboard and unplug the USB cable. If wireless, remove the battery or switch the power slider to Off. This prevents accidental key presses or short circuits. Common mistake: Leaving the keyboard connected can cause the RGB to flash or the board to register phantom inputs during the swap.
Remove the Keycap: Use a keycap puller to gently lift the keycap straight up. Avoid twisting or rocking, which can damage the switch stem or stabilizer. Set the keycap aside. Checkpoint: If the keycap feels stuck, use a flat plastic spudger to gently pry from one corner—never force it.
Pull the Old Switch: Grip the switch from the top and bottom with the switch puller, squeeze, and pull straight upward. The switch should release with a light pop. If it resists, double-check that the puller is gripping the housing, not the stem. Common mistake: Pulling at an angle can bend the switch pins or damage the hot-swap socket. Always pull vertically.
Align and Insert the New Switch: Examine the new magnetic switch: the pins are usually offset or have a small notch. Align them with the socket's opening—do not force. Gently press down until you hear or feel a click. The switch should sit flush with the plate. Checkpoint: If the switch does not click in, remove it, check pin alignment, and try again. Never hammer or push with excessive force.
Replace the Keycap and Test: Press the keycap back onto the switch stem until it snaps. Reconnect the keyboard and power it on. Open a text editor or use the keyboard's driver to verify that every swapped key registers correctly. Final step: If a key does not respond, power off and reseat the switch. Persistent issues may indicate a bent pin or a faulty switch.

Product Facts

ATTACK SHARK X820 ULTRA Tri-mode Gasket Mechanical Keyboard: Interactive TFT Screen & Control Knob The ATTACK SHARK X820 Ultra Wireless mechanical keyboard features a smart TFT color display that shows time, battery level, connection status, and RGB backlight effects. Easily customize GIF animations via the driver. The precision CNC metal knob lets you scroll menus and press to adjust lighting brightness, speed, and system settings. The X820 Ultra is a tri-mode gasket keyboard with a hot-swap PCB, so you can easily replace switches while enjoying its customizable screen and knob for system control.